RP-8000 MK2

You can use Stems by doing a custom MIDI Mapping in Serato DJ Pro:
MIDI mapping Stems with Serato DJ Pro
Note: You need to have installed at least Serato DJ Pro 3.0

Please check whether this only happens when a USB connection is established between the RP-8000 MK2 and Serato DJ Pro. If this is the case, an existing hardware remapping from Serato DJ Pro might be causing the problem.
Learn more here:
MIDI conflict (Buttons activating the wrong functions on a supported device)
You can also simply disable "Allow Hardware Remapping" as follows:

The RP-8000 MK2 should be connected to the computer via USB. Make sure you are using the latest version of Serato DJ Pro. The RP-8000 MK2 was released with version 2.1.0 of Serato and has been compatible since then. The latest Serato DJ Pro version can be downloaded here:
https://serato.com/dj/pro/downloads
The RP-8000 MK2 is an Official Serato Accessory. However, it does not activate the software. You need a Serato DJ Pro DVS capable hardware with the appropriate license. Learn how to activate DVS in Serato DJ Pro:
https://serato.com/activation/dvs

By holding the SHIFT and LOOP buttons and simultaneously turning on the turntable, you will enter the advanced setup menu.
Now each drum pad has a function of its own that can be turned on/off.
When lit green, the function is activated, when lit red, the function is deactivated.

1. Power off the RP-8000MK2 turntable.
2. Hold „SHIFT“ + „SMPL“-buttons while powering on the unit via the power switch.

You can find more detailed information in our Firmware Upgrade Guide.

Press and hold Shift and use the +16%-button to change display mode.
The following modes are available:
1. Pitch Fader Position
2. BPM (Serato DJ Pro)
3. Elapsed Time (Serato DJ Pro)
4. Ramain Time (Serato DJ Pro)

Learn the basics about Platter Play in our DYK video series on our Youtube Channel.
You can find more detailed information in our Platter Play PDF .